Felix Miata wrote, On 12/18/2007 10:11 PM:
On 2007/12/18 18:27 (GMT-0800) Tod Merley apparently typed:
On Dec 18, 2007 12:53 PM, Felix Miata <mrmazda@xxxxxx> wrote:
On 2007/12/18 01:55 (GMT-0500) Felix Miata apparently typed:
I replaced the HD and installed again (try ~#8). Boot still halts after:
<SNIP>
3. In your CMOS utility look for parameters which relate to how the
disk is "talked" to. Change it from what is probably "auto" to your
best guess made by reading your disk service manual. If there are
delay parameters which appear to relate to disk communication you
might consider changing them as well.
I learned long ago that setting the BIOS to use anything other than AUTO was
more likely to do more harm than good, so I NEVER do it any more.
http://mrmazda.no-ip.com/partitioningindex.html#BIOSHDREC
except sometimes you actually need to configure programs (like bios) do do
things in an expected way.
The problem you described reminded me of a problem one of the guys had while
attempting to install F8T3, IIRC it was solved by either forcing AHCI on or
off in bios, I don't remember which and he is not here right now.
however reading
http://mrmazda.no-ip.com/tmp/anacdump-gx150-f8-live1.txt
I noticed fairly early on...
"Local variables in innermost frame:
...
deviceFile: /dev/sda
str: The drive /dev/sda has more than 15 partitions on it. The SCSI subsystem
in the Linux kernel does not allow for more than 15 partitions at this time.
You will not be able to make changes to the partitioning of this disk or use
any partitions beyond /dev/sda15 in Fedora
...
"
So I am assuming your F7 install only used partitions numbered less than 15??
It looks like the Anaconda in F8 is less forgiving (capable of dealing with
errors) about too many partitions or you asked it to install to a partition
numbered > 15?
--
Todd Denniston
Crane Division, Naval Surface Warfare Center (NSWC Crane)
Harnessing the Power of Technology for the Warfighter
