On Wed, 2 Feb 2011, Kevin J. Cummings wrote: > On 02/02/2011 08:35 PM, Michael Hennebry wrote: >> On Wed, 2 Feb 2011, Kevin J. Cummings wrote: >> >>> Let's start at the beginning: >>> >>> What is the output of "lspci | grep VGA" >> >> 01:00.0 VGA compatible controller: ATI Technologies Inc Mobility Radeon HD 3600 Series > > I can't find this on the Wikipedia Radeon Chipset Comparison page. > Assuming its either a 3670 or a 3680, it would have an RV635 chipset > which is supported by the radeon driver. According to the box, it's a Vision Tek Radeon HD3650. >>> Also, what video driver are you using to drive it? >> [hennebry@localhost log]$ grep river Xorg.0.log >> [ 24.065] (WW) AllowEmptyInput is on, devices using drivers 'kbd', >> 'mouse' or 'vmmouse' will be disabled. >> [ 24.065] X.Org Video Driver: 7.0 >> [ 24.065] X.Org XInput driver : 9.0 >> [ 24.237] (II) Loading /usr/lib/xorg/modules/drivers/radeon_drv.so >> [ 24.308] Module class: X.Org Video Driver >> [ 24.308] ABI class: X.Org Video Driver, version 7.0 >> [ 24.309] (II) RADEON: Driver for ATI Radeon chipsets: >> [ 24.345] ABI class: X.Org Video Driver, version 7.0 >> [ 24.352] ABI class: X.Org Video Driver, version 7.0 >> [ 24.561] ABI class: X.Org Video Driver, version 7.0 >> [ 24.949] (II) EXA(0): Driver registered support for the following >> operations: >> [ 25.125] (II) AIGLX: enabled GLX_texture_from_pixmap with driver >> support >> [ 25.803] Module class: X.Org XInput Driver >> [ 25.803] ABI class: X.Org XInput driver, version 9.0 >> [ 26.094] (II) No input driver/identifier specified (ignoring) >> [hennebry@localhost log]$ > > Yeup, you're using the RADEON driver. That's good. > >>> look in your /etc/X11/xorg.conf file if you have one.) >> >> Section "Device" >> #... >> Identifier "Card0" >> Driver "radeon" >> VendorName "ATI Technologies Inc" >> BoardName "Mobility Radeon HD 3600 Series" >> BusID "PCI:1:0:0" > > OK, you have it specified down to a tee. B^) > >>> Finally, what is the result of "glxinfo | grep direct" >> >> [hennebry@localhost X11]$ glxinfo | grep direct >> IRQ's not enabled, falling back to busy waits: 2 0 >> direct rendering: Yes > > And that shows that the 3D support is up and running. > Let's concentrate on mplayer. Does it work any better if you specify > "-vo xv" or "-vo xvidix"? >From the command line I tried xv: DRI failure, pixelation gl_nosw: pixelation, but no DRI failure message dga: mess fbdev: cannot open /dev/fb, no video xvidix: pci errors, no video x11: DRI failure, pixelation dga: mess: Movie-Aspect is undefined - no prescaling applied. VO: [dga] 640x480 => 640x480 BGRA vo_dga: DGA 2.0 available :-) Can switch resolution AND depth! vo_dga: Selected hardware mode 640 x 480 @ 59 Hz @ depth 24, bitspp 32. vo_dga: Video parameters by codec: 640 x 480, depth 24, bitspp 32. vo_dga: Framebuffer mapping failed!!! FATAL: Cannot initialize video driver. Too many buffered pts > I have an M56P chipset (Mobility Radeon X1600) and I have no trouble > playing .mpg files with -vo xv. Your chipset is supposed to be better > than mine (mine isn't HD). > > What type of file are you trying to play? Usually flash from my hard drive. I'll see if .mpg is better. I should have mentioned this before: The degree of pixelation is not constant. The longer I play the worse it gets. Rebooting doesn't help. Sometimes waiting a week does. Pixelation comes in spurts. I'm in the middle of a spurt that was preceeded by a long period of good video. -- Michael hennebry@xxxxxxxxxxxxxxxxxxxxx "Pessimist: The glass is half empty. Optimist: The glass is half full. Engineer: The glass is twice as big as it needs to be." -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
