Hello:
I am running FC-4, and I have been trying to configure my wireless
connection. Apparently Everything is all right:
# Ifconfig
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:3128 errors:0 dropped:0 overruns:0 frame:0
TX packets:3128 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:3770918 (3.5 MiB) TX bytes:3770918 (3.5 MiB)
ppp0 Link encap:Point-to-Point Protocol
inet addr:148.221.119.60 P-t-P:148.235.20.172
Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1500 Metric:1
RX packets:281 errors:0 dropped:0 overruns:0 frame:0
TX packets:314 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:189816 (185.3 KiB) TX bytes:43672 (42.6 KiB)
wlan0 Link encap:Ethernet HWaddr 00:06:25:48:3C:17
inet6 addr: fe80::206:25ff:fe48:3c17/64 Scope:Link
UP BROADCAST RUNNING MTU:1500 Metric:1
RX packets:2089 errors:0 dropped:0 overruns:0 frame:0
TX packets:14 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
-------
But when I try to connect, I get:
[root@pauli gcovar]# ifup wlan0
Error for wireless request "Set Bit Rate" (8B20) :
SET failed on device wlan0 ; Invalid argument.
Determining IP information for wlan0... failed.
----------------------
Does anyone know what this error is and how to correct it? Any feedback
will be appreciated.
Teilhard.
