Well, it wont be in the reader section because it is a recorder. I'm assuming you've tried to use it as a reader with k3b and it didnt work? If you still cant get it to work, you could try the old hdx=ide-scsi and try it. (dont know if fc2 comes with it built in tho) Does cdrdao or cdda-wav work manually? Have you run the k3b-setup proggy? Does k3b give you any messages at all on startup? Good luck, Matt On Fri, 13 Aug 2004 21:28:34 -0300, Andre Costa <acosta@xxxxxxxxxxxxxxxxxxx> wrote: > Just for the record, upgrading firmware to 1.03 enabled CD-burning with > xcdroast. k3b still doesn't recognize the drive as a reading device. > > Best, > > Andre > > On Sun, 8 Aug 2004 17:23:28 -0300 > Andre Costa <acosta@xxxxxxxxxxxxxxxxxxx> wrote: > > > Hi, > > > > I just bought a new LG GCC-4521B DVD CDRW combo, and I am having a > > tough time trying to make it read/write cds with FC2. > > > > k3b does recognize it as a recording device (although it doesn't > > detect automatically the maximum writing speed), but it doesn't see it > > as a reading device. According to this item on k3b FAQ > > [http://k3b.plainblack.com/index.pl/faq#3] this could be cdrdao's > > fault. > > > > cdrdao almost does it if I give it a hand with --device ATA:1,0,0 > > --driver generic-mmc-raw : > > > > # cdrdao read-toc --device ATA:1,0,0 --driver generic-mmc-raw test.toc > > > > Cdrdao version 1.1.8 - (C) Andreas Mueller > > <andreas@xxxxxxxx> SCSI interface library - (C) Joerg Schilling > > Paranoia DAE library - (C) Monty > > > > Check http://cdrdao.sourceforge.net/drives.html#dt for current driver > > tables. > > > > Using libscg version 'schily-0.8' > > > > ATA:1,0,0: HL-DT-ST RW/DVD GCC-4521B Rev: 1.00 > > Using driver: Generic SCSI-3/MMC (raw writing) - Version 2.0 (options > > 0x0000) > > > > Reading toc data... > > > > Track Mode Flags Start Length > > ------------------------------------------------------------ > > 1 DATA 4 00:00:00( 0) 68:14:54(307104) > > Leadout DATA 4 68:14:54(307104) > > > > PQ sub-channel reading (data track) is supported, data format is BCD. > > Raw P-W sub-channel reading (data track) is supported. > > Analyzing track 01 (MODE1): start 00:00:00, length 68:14:54... > > > > Reading of toc data finished successfully. > > > > ======= > > > > However, I can't seem to make it work with k3b; I tried providing the > > same parameters above to cdrecord on k3b's programs tab, but it didn't > > help. > > > > Any hints will be much appreciated. > > > > TIA > > > > Andre > > > > -- > > Andre Oliveira da Costa > > > > > > -- > > fedora-list mailing list > > fedora-list@xxxxxxxxxx > > To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list > > -- > Andre Oliveira da Costa > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list >
