> Hello Everyone9, > If the output of "/sbin/lspci | grep VGA" is: > 03:00.0 VGA compatible controller: nVidia Corporation G94 [GeForce 9600 GT] (rev > a1) > > are the correct instructions for installing the proprietary NVidia driver still > located here: > http://fedorasolved.org/video-solutions/nvidia-yum-kmod > > I have tried the above referenced instructions a couple of times, with the same, > bad results... I am now going to try again, paying special attention to the > "Troubleshooting" section... With this exact system, I have been so used to > everything working (up until I installed Fedora 13) that I have never even had > to look at the troubleshooting steps for these instructions before. > > I will get back to you with whatever happens. Hello Everyone, Since nothing has been figured out about this issue that I'm having yet, I thought I'd give you a lot more detail about my system: Main System: SuperMicro SuperWorkstation SYS-5046A-XB Motherboard: SuperMicro Super C7X58 ICPU: ntel(R) Xeon(R) QuadCore CPU E5504 2.00GHz Memory: 8GB of RAM: Kingston ValueRAM 4GB (2 x 2GB) 240-Pin DDR3 SDRAM DDR3 1333 (PC3 10600) Dual Channel Kit Video Card: nVidia GeForce 9600 GT (512MB of DDR2 memory on board.) Like I've said elsewhere in this thread, the proprietary nVidia drivers from rpmfusion worked great on this same system under Fedora 12. I even used the same instructions TRYING to get it to work under Fedora 13 that I used to SUCCESSFULLY get it working under Fedora 12. Also, both my Fedora 12 and my current Fedora 13 installs were full installs from the DVD. They were NOT upgrades, I completely wiped out the previous Fedora install. Steven P. Ulrick -- users mailing list users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe or change subscription options: https://admin.fedoraproject.org/mailman/listinfo/users Guidelines: http://fedoraproject.org/wiki/Mailing_list_guidelines
