On Tue, 2006-12-12 at 23:29 +0100, roland wrote: > On Tue, 12 Dec 2006 16:36:22 +0100, Aaron Konstam <akonstam@xxxxxxxxxxxxx> > wrote: > > > On Mon, 2006-12-11 at 23:12 +0100, roland wrote: > >> On Mon, 11 Dec 2006 23:43:04 +0100, Aaron Konstam > >> <akonstam@xxxxxxxxxxxxx> > >> wrote: > >> > >> >> When a message is to be printed in evolution, it calls an interface > >> >> with > >> >> an entry like settings - configure: > >> >> After a click on the configure a submenu is displayed with a box > >> duplex, > >> >> which is always selected. This gives me problems with some printers. > >> >> when > >> >> deselected, the select comes back after loging off en loging back in. > >> >> > >> >> Is there a way to definitely unselect this box or to connect another > >> >> print-interface? > >> >> > >> >> Thanks > >> >> -- > >> >> Roland Brouwers > >> >> C.A.T. bvba > >> >> > >> > That is strange. When I print in evolution it gives me a choice > >> between: > >> > 1. Create a PDF document > >> > 2. Genetic Postscript printer (default) > >> > 3. my default printer set by cups or lpoptions. > >> > Both option 2 and 3 print to my default printer. > >> > >> If you go more down then you will see this > >> settings - Default - Configure > >> Clicking on Configure will lead you to the little window with this > >> 'duplex' option. > > You are right but in doing that I learned something. When I printed > > before option 2. above was the default option. However, highlighting > > option 3 and clicking default changed that. I also noticed that the > > option checked is dependent on the printer you choose to print to. So in > > my case the Generic Postscript corresponded to Duplex being checked and > > my default printer had neither duplex not tumble checked. Again this > > could be changed and would remain for the printer it was identified > > with. > >> From this I assume that you need a choice in the display to correspond > > to the kind of printer(s) you are using. > > > Could you explain this in another way. I don't understand. I am never able > to change the default option. Actually now I am trying to explain it to myself. I goofed. There is no doubt that the configuration settings are tied to the printer used to print. So using the list above, on my machine option 2. is tied to the Duplex configuration and option 3. has neither Duplex or tumbled checked. I suspect this is tied to the printer definition. What I managed to do with Default is to make option 3. (my local printer) the default instead of option 2. But when I exited evolution and restarted it the old defaults were back. So I failed to do what you wanted to do. I am sorry I was so optimistic when I sent you the message. > -- ======================================================================= Dirksen's Three Laws of Politics: (1) Get elected. (2) Get re-elected. (3) Don't get mad, get even. -- Sen. Everett Dirksen ======================================================================= Aaron Konstam telephone: (210) 656-0355 e-mail: akonstam@xxxxxxxxxxxxx
