On Fri, 24 Nov 2006, Axel Thimm wrote:
On Thu, Nov 23, 2006 at 08:57:26PM -0700, Kevin Kempter wrote:
On Thursday 23 November 2006 18:58, Matthew Saltzman wrote:
On Thu, 23 Nov 2006, Erik Hemdal wrote:
On 23/11/06, Cecilia Lunardini <cecilialunardini@xxxxxxxxx> wrote:
So, my question is: is there a step by step, guide on how to
set up the wireless? It has to be very detailed, because I am
an absolute beginner and even the most obvious aspects of
Linux are not obvious to me.
Try this guide (for Fedora Core 6) and see if you can follow it
through (I think the only missing element from a Fedora
installation to get Centrino wireless working is the Intel
firmware that needs to be downloaded):
http://www.ces.clemson.edu/linux/fc2-ipw2200.shtml
The Clemson instructions are very good and step by step. Take a
few minutes to read over all of it to get an idea of what you're
in for, because it's very detailed. There are several steps you
need to do before you can simply check for the detection of the
card.
This worked for me.
1) download the v3.0-9 firmware from
http://atrpms.net/dist/common/ipw2200-firmware/
2) download the driver (ipw2200-1.2.0-45.fc6.at.i386.rpm ) and the appropriate
kernel module (such as
ipw2200-kmdl-2.6.18-1.2849.fc6-1.2.0-45.fc6.at.i686.rpm ) from here:
http://atrpms.net/dist/fc6/ipw2200/
3) run "yum install ieee80211-kmdl-2.6.18-1.2239.fc5-1.2.15-14.fc5.at" as root
to satisfy dependancies before you install the rpm's (or try and install the
RMP's and yum the module it gripes about)
4) install the rpm's you downloaded in steps 1 & 2
Hi,
steps 1)-4) can be simply abbreviated with
yum install ipw2200
if you have ATrpms activated as a repo.
Of course, you have now (probably unnecessarily) climbed on a treadmill
where every kernel update requires an update of these modules. That's OK
if you know you want or need the benefits of the newer module versions,
but most people don't (need or want or know).
Centrino wireless now Just Works(tm) (once firmware is installed), unless
there is something unusual about your hardware or operational procedures.
What advantages do the ATRPMs offer, other than the updated driver
versions?
5) reboot, then go to Administration --> network (or the gnome equivelant) and
create a new wireless device. Your ipw2200 centrino device should now show
up.
Hope this helps...
--
Matthew Saltzman
Clemson University Math Sciences
mjs AT clemson DOT edu
http://www.math.clemson.edu/~mjs
