Anne Wilson wrote: > On Friday 10 November 2006 18:22, Mike McCarty wrote: >>> Hi Mike, >>> >>> You may want to read up here: >>> >>> http://reactivated.net/writing_udev_rules.html >>> >>> Hope this helps, >> I have only just very briefly looked at the subject, and it indeed >> seems to address the issue. I have yet to ascertain whether it >> is the solution I'm looking for. But I'm sending this just to say: >> >> Thanks so much for the pointer. >> > Mikkel Ellertson did quite a bit of work on that - I benefitted from it at the > time - when hal and udev first started. I wonder where he is? I haven't > seen him around lately. > > Anne > I pop in now and then. But not as much as I used to. As far as mounting goes, you may want to give the file system labels, and let HAL auto-mount them. The drive then gets mounted on /media/<label> when it is plugged in. If there is more then one partition on the drive, then each gets mounted off of /media. If the partitions are not labeled, then HAL has some other rules it uses to construct the names. The auto-mounting will normally make FAT file systems owned by the user who "owns" the console. You can also turn off auto-mounting in the GUI. If you have special requirements for how the drive gets mounted, then you can ether write HAL rules to cover it, or you can have udev create a special device name or symlink based on the device. Vendor ID and device ID are usually enough, but you can also use the serial number. I can give better advice if I know exactly what you are after. I am not an expert on this. But I have played around enough that I can probably point you in the right direction. Mikkel -- Do not meddle in the affairs of dragons, for thou art crunchy and taste good with Ketchup!