Scot L. Harris wrote:
The two addresses you give are in two different subnets. Most APs I have seen default to the first address in the subnet defined on the LAN side. In you case you might try 192.168.2.1 as the address oof the AP.
Or if it is following what you indicate the default should be try 192.168.2.50.
Baring that you will have to see about a hard reset which should reset the device back to factory defaults at which point the address should be 192.168.0.50 and have the default password info.
Normally there is a reset button, small hole with a switch that you
reach with a paperclip reset device.
Thanks for your help, Scot. I think I covered your points in my previous reply to Rick.
-- Claude Jones Bluemont, VA, USA
