On Fri, Feb 25, 2005 at 08:12:55AM -0600, Jay Paulson wrote: > I have just installed Fedora Core 3 on my AMD 64 and everything went > smoothly. After installation I get the following message: > r8169: eth0: PHY reset until link up > I have googled this error and haven't found anything to help me out > trying to figure out what the problem is. My only guess is that the > network interface is not connecting to the network for some reason. > Any suggestions on what steps I should take? I have no solution. I reported the same problem on both the amd64-list and fedora-list with subject 'ethernet failure after update to kernel-2.6.10-1.766' (16 Feb). But nobody volunteerd a solution though one other user confirmed seeing this. Did you experience it immediately after the install with the 2.6.9 kernel or after updating to 2.6.10? I was able to work for 2 months with the 2.6.9 kernel and updates upto and including 2.6.10-1.760 without this occuring. It started after update to 2.6.10-1.766 (immediately after rebooting) and then also appeared with the older kernels. Sometimes it disappeared for a couple of days before surfacing again. (Luckily I have another inegrated ethernet adapter in the mobo that works without problems). Can anybody here can confirm wether this is a hardware problem or a kernel/driver problem. In the latter case I will bugzilla it. Alexander
