On Mon, 2004-11-22 at 09:01, eric tanguy wrote: > I would like to know if the prism54 driver is included in fc2 and/or fc3? > I've also read that this driver need a firmware and that during the boot > process the hotplug process is disabled. So it seems that during the boot > process the firmware is not able to be uploaded and the wifi activation > can't be achieved during the boot process. > Any comments ? > Eric I have been using the prism54 driver with a D-Link DWL-G650 card for some time now on FC2. For FC2 this was not included, I installed it from the prism54.org web site (I think that is the correct URL). Was fairly easy to setup once I understood the part about the firmware and had that copied to the correct directory. For FC2 at least you need to configure the interface NOT to start at boot time. When pcmcia services start the interface card will be started anyway. In my case for FC2 this works since I have just the one pcmcia interface card installed at a time. -- Scot L. Harris webid@xxxxxxxxxx Dow's Law: In a hierarchical organization, the higher the level, the greater the confusion.
