Hi I think I have done all I have found in the archive and documentation to get my palm running with FC3 (pilot-xfer and evolution). 1) I created the 10-local.rules which contains: *rsy@puffin*[23:13][/home/rsy][43]> cat /etc/udev/rules.d/10-local.rules # For my Palm T2 KERNEL="ttyUSB1",MODE="666",SYMLINK="pilot" If I press the hotsync-button of my palm I get the following messages in /var/log/messages: Nov 15 23:22:17 puffin kernel: usb 1-1: new full speed USB device using address 9 Nov 15 23:22:17 puffin kernel: visor 1-1:1.0: Handspring Visor / Palm OS converter detected Nov 15 23:22:17 puffin kernel: usb 1-1: Handspring Visor / Palm OS converter now attached to ttyUSB0 Nov 15 23:22:17 puffin kernel: usb 1-1: Handspring Visor / Palm OS converter now attached to ttyUSB1 Nov 15 23:22:19 puffin kernel: usb 1-1: control timeout on ep0in attached 9 There is now way to establish an connection to transfer data from an to the palm. Also there is not message that the username is transfered/verified on the palm. The palm still hangs for approx. 2 minutes and then displays a message the connection timed out. If I start pilot-xfer (after pressing the hotsync button on the palm) I get the following: *rsy@puffin*[23:10][/home/rsy][42]> pilot-xfer -b privat/Palm/backup/ No $PILOTPORT specified and no -p <port> given. Defaulting to '/dev/pilot' Listening to port: /dev/pilot Please press the HotSync button now... And that's it until I press Ctrl-C .... I am using a Dell Latitude C800 with USB 1 - does this is the Problem ? With FC2 I had no problem with my palm and pilot-xfer. Thanks for any information to make it runnable Reinhard
