clint@xxxxxxxxxxxxxxxxxxxx wrote:
Bill Tetens wrote:
I got some advice about loading Totem to play movies with the DVD
drive I just installed.
Using the instructions I inslalled lidvd* libMad* totem* using Yum
from Dag and as far as I can tell the install went without a hitch.
I don't know if this will address the specific error that you are
getting, but double-check the libdvd* libmad* above. There are errors,
spelling and capitalization, in what you provided that would prevent
Totem from working properly.
Here is the correct command you'll want:
# yum install libdvd* libmad* totem*
Hope this helps,
Clint
When I try to start the Totem movie player I get the followin error
message. Any one got any help I hope so.
Error message:
Totem could not startup
Could not link video output thread (cs and balance}
If you have a solution give me a lot of details as I am still a
beginner.
Thanks
Bill
I tried another Yum update and it told me that those three items were
not available so I assure they are installed. I probably only made the
errors when I wrote the e-mail and did not pay attention. When I enter a
command I always try to double check my typing which can be bad at times.
