On 01-Sep-2004 Clint Harshaw wrote: > Bill Tetens wrote: > > I got some advice about loading Totem to play movies with the DVD drive > > I just installed. > > > > Using the instructions I inslalled lidvd* libMad* totem* using Yum from > > Dag and as far as I can tell the install went without a hitch. > > I don't know if this will address the specific error that you are > getting, but double-check the libdvd* libmad* above. There are errors, > spelling and capitalization, in what you provided that would prevent > Totem from working properly. > > Here is the correct command you'll want: > > # yum install libdvd* libmad* totem* I would say: yum install 'libdvd*' 'libmad*' 'totem*' Joachim Backes -- Joachim Backes <backes@xxxxxxxxxxxxxx> University of Kaiserslautern,Computer Center, High Performance Computing Department, D-67653 Kaiserslautern, PO Box 3049, Germany -------------------------------------------------- Phone: +49-631-205-2438, FAX: +49-631-205-3056 http://hlrwm.rhrk.uni-kl.de/home/staff/backes.html > > Hope this helps, > Clint > > > > > > When I try to start the Totem movie player I get the followin error > > message. Any one got any help I hope so. > > > > Error message: > > > > Totem could not startup > > Could not link video output thread (cs and balance} > > > > If you have a solution give me a lot of details as I am still a beginner. > > > > Thanks > > Bill > > > > > > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
