On Mon, 2004-08-30 at 07:21, Tom Conway wrote: > Thanks, the server is a used proliant. I've used them several time. This > one had 2 nics in it and I assumed it would not be a problem since the > cards were already installed. I've never had 2 nics at once. I assumed the > intallation would handle it, didn't give it much thought... my error. > > I'll give the ifdown/ifup a shot tonight. > Where is the config file that I can comment out the "activate on boot" for > eth1? > > Thanks > /etc/sysconfig/network-scripts/ifcfg-eth1 > > On Sun, 29 Aug 2004, Tom Conway wrote: > > > >> The issue is definetly network, my server has 2 cards, > >> 192.168.0.15 > >> 192.168.0.20 (currently no cable connected) > >> > >> > >> IP ROUTE > >> 192.168.0.0/24 dev eth1 scope link > >> 192.168.0.0/24 dev eth1 proto kernel scope link src 192.168.0.20 > >> 169.254.0.0/16 dev eth1 scope link > >> 127.0.0.0/8 dev lo scope link > >> default via 192.168.0.1 dev eth1 > > ^^^^ > > > > There is at least part of your problem. eth1 is the interface you said you > > do not have a cable connected to. Try doing ifdown eth0, ifdown eth1, and > > then do an ifup eth0. Then see what interface your default route is > > through. > > It should then be pointed at eth0. > > > > Question, why do you have 2 interfaces on the same network up at the same > > time? > > If you are planning to turn thei into a firewall then the addresses for > > each > > interface should be on 2 different networks. > > > >> > >> IP ADDRESS > >> 1: lo: <LOOPBACK,UP> mtu 16436 qdisc noqueue > >> link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00 > >> inet 127.0.0.1/8 brd 127.255.255.255 scope host lo > >> inet6 ::1/128 scope host > >> valid_lft forever preferred_lft forever > >> 2: eth0: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000 > >> link/ether 00:50:8b:d6:33:89 brd ff:ff:ff:ff:ff:ff > >> inet 192.168.0.15/24 brd 192.168.0.255 scope global eth0 > >> inet6 fe80::250:8bff:fed6:3389/64 scope link > >> valid_lft forever preferred_lft forever > >> 3: eth1: <BROADCAST,MULTICAST,UP> mtu 1500 qdisc pfifo_fast qlen 1000 > >> link/ether 00:50:8b:ae:f5:f0 brd ff:ff:ff:ff:ff:ff > >> inet 192.168.0.20/24 brd 192.168.0.255 scope global eth1 > > ^^^^^^^^^^^^^^^ > > You said there is no cable on this interface. > > > >> inet6 fe80::250:8bff:feae:f5f0/64 scope link > >> valid_lft forever preferred_lft forever > >> 4: sit0: <NOARP> mtu 1480 qdisc noop > >> link/sit 0.0.0.0 brd 0.0.0.0 > > > > HTH, > > > > Tom > > > > > > -- > > fedora-list mailing list > > fedora-list@xxxxxxxxxx > > To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list > > > > > -Later >
