All,
I just recently started having a problem with FC2 on a brand-new
Dell PowerEdge 2650 server with dual built-in NetXtreme BCM5703
Gigabit Ethernet interfaces in that every so often, seemingly on
its own, FC2 will forget its default route.
The setup is as follows:
eth0 -> 192.168.0.2
eth1 -> 192.168.0.3
(note they are both on the same subnet)
When I issue the route command, I get:
Kernel IP routing table
Destination Gateway Genmask Flags Metric Ref Use Iface
192.168.0.0 * 255.255.255.0 U 0 0 0 eth0
192.168.0.0 * 255.255.255.0 U 0 0 0 eth1
...then it hangs for up to 30 seconds before it returns the last
line, the default route:
default 192.168.0.1 0.0.0.0 UG 0 0 0 eth0
I have tried adding to /etc/sysconfig/network a line as follows:
GATEWAY="192.168.0.1"
But that didn't seem to work.
Any clues guys? Thanks in advance for any help you can provide.
Andrew
--
ANDREW DIETZ
Systems Administrator
Georgia Institute of Technology
Library and Information Center
704 Cherry Street
Atlanta, GA 30332-0900
----------------------------------------------------------------------
This email was composed using the GTEL Webmail client.
The information transmitted is intended only for the person or entity
to which it is addressed and may contain confidential and/or
priviledged material. Any review, retransmission, dissemination or
other use of, or taking of any action in reliance upon, this
information by persons or entities other than the intended recipient
is prohibited.
Georgia Tech Library and Information Center
http://www.library.gatech.edu
----------------------------------------------------------------------
