On Tue, 2004-07-13 at 10:03, Alexander Dalloz wrote: > Am Di, den 13.07.2004 schrieb Cokey de Percin um 4:10: > > > I have a Tyan 2500 (Thunder) board with dual channel onboard Symbios > > 53C1010-33 controller. Currently the system is running RH 7.3 with > > patches, upgrades & Kernel 2.4.10. When I try install Core 2, the > > controller is found, but I get 'detaching/resetting' messages and the > > installation stalls. I doubt that this is a hardware problem as this > > system has been running for several years with no problems and no > > hardware changes and still runs correctly under 7.3. I did notice that > > Core 1/2 both seem to use a 'new' version of the Symbios driver, while I > > use the older version in the sytems 2.4.10 kernel. I can't post the > > error messages as I don't get far enought to capture them. I'd > > appreciate it if anyone can shed some light on this problem. > > > Cokey > > You may boot into installation with "linux noprobe" and then manually > choose the SCSI driver. > > Alexander Yes, I can do that but how does that fix the problem? AFAIK, the NCR and original sysmbios drivers don't exist in Core 2, just Ver 2 of the Symbios driver. Cokey -- ------------------------------------------------------------------ F. 'Cokey' de Percin, DBA Email: CSC Work - cdeperci@xxxxxxx Columbia, South Carolina Home - fdepercin@xxxxxxxxx -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. Mailscanner thanks transtec Computers for their support.
