On Sun, 2004-07-04 at 18:06, Mike Payst wrote:
> Michael Schwendt wrote:
>
> >?? ALSA is included in FC2, so you should have alsa-lib and alsa-utils at
> >least.
> >
> >
> My error. The alsa rpms installed are:
> alsa-lib-1.0.3a-2
> alsa-utils-1.0.3-1
>
> >
> >The alsactl lines are missing:
> >
> >install snd-intel8x0 /sbin/modprobe --ignore-install snd-intel8x0 && /usr/sbin/alsactl restore >/dev/null 2>&1 || :
> >remove snd-intel8x0 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ; }; /sbin/modprobe -r --ignore-remove snd-intel8x0
> >
> >
> My /etc/modprobe.conf is now:
>
> alias eth0 3c59x
> alias eth1 forcedeth
> # kill IPV6 - 02Jul2004MWP
> alias net-pf-10 off
> alias usb-controller usb-uhci
> alias usb-controller1 usb-ohci
> alias usb-controller2 ehci-hcd
>
> install snd-intel8x0 /sbin/modprobe --ignore-install snd-intel8x0 &&
> /usr/sbin/alsactl restore >/dev/null 2>&1 || :
> remove snd-intel8x0 { /usr/sbin/alsactl store >/dev/null 2>&1 || : ; };
> /sbin/modprobe -r --ignore-remove snd-intel8x0
>
> # --- BEGIN: Generated by ALSACONF, do not edit. ---
> # --- ALSACONF verion 1.0.3 ---
> alias snd-card-0 snd-intel8x0
> alias sound-slot-0 snd-intel8x0
> # --- END: Generated by ALSACONF, do not edit. ---
>
> >ALSA starts with various audio channels set to volume zero and "mute".
> >system-config-soundcard pushes up the volume level for the test sound.
> >And the user should run alsamixer, un-mute the channels, and the
> >shutdown/reboot process would save the mixer settings. modprobe.conf would
> >restore them at boot time upon loading the kernel drivers.
> >
> >
> Used alsamixer to set the volume levels that were settable (all but 2)
> and still no change in behavior with RealPlayer8 (I still have the RP8
> from FC1 installed).
>
I had to set volumes in 2 mixers to get my clean install with only the
alsa drivers loaded to work.
alsamixer and aumix.
