On Sun, 27 Jun 2004 21:32:23 -0400, Greg Swallow <gswallow@xxxxxxxxxx> wrote:
> where # is 0, 1, then 2
>
> ln -s /dev/ttyUSB# /dev/pilot (create default /dev for gnome-pilot)
>
> chmod 666 /dev/ttyUSB# (0, 1, and 2)
> chmod 666 /dev/pilot (the new /dev)
>
Your instructions are a little unclear -- are you saying you should do
the link (the ln command) for all three files? 'Cos that won't work
-- once the first file is linked to that file name (/dev/pilot), ln
will give you the error message that the file already exists. The
/dev/pilot link needs to be made *only* to the /dev/ttyUSB? device on
which your particular device passes data (although they all open two
channels, only one is used for data -- the other is (at a guess) for
communication control).
On a Tungsten-line handheld, that port is /dev/ttyUSB1. On an m5xx,
it's /dev/ttyUSB0. To figure out which it is for your particular
device, kill off gpilotd, and try the following (after changing the
permissions on the ports as above)...
pilot-xfer -p /dev/ttyUSB{0 or 1} -l
...which will print a list of all the databases on your handheld (if
the connection port was the correct one). If it just hangs, do a
Ctrl-C and try the other port.
--
Ben Steeves
ben.steeves@xxxxxxxxx
GPG ID: 0xB3EBF1D9
http://www.metacon.ca/
