Hi Antonio, Hi Alexander, Am Mo, den 21.06.2004 schrieb Alexander Dalloz um 22:05: > Am Mo, den 21.06.2004 schrieb antonio montagnani um 21:48: > > > I deleted AVM Fritz card from system-config-network and rebooted. But you did not configure a new isdn device as I told you!? system-config-network -> Hardware -> New -> ... This should add the correct values to /etc/sysconfig/isdncard: $ cat /etc/sysconfig/isdncard RESOURCES='protocol=2 type=27 id=HiSax' NAME='AVM PCI (Fritz!PCI)' MODULE=hisax VENDOR_ID=1244 FIRMWARE= > > I do not see any eth2 (I have already two ethernet cards in > > modprobe.conf... and I do not see any alias eth2 hisax... > > alias eth0 ne2k-pci > > alias eth1 ne2k-pci > > #alias eth2 hisax (it was commented after upgrade from FC1 to FC2 as it > > was not working any way..even with uncommented no hisax module loaded > > > > and no hisax module loaded if I play with lsmod... It's loaded by /etc/init.d/isdn. Therefore the card has to be properly configured in /etc/sysconfig/isdncard. > > > Antonio Montagnani > > And what happens if you run "service isdn start"? GOOD Question! :-) > > You might add > > alias char-major-43 hisax > alias char-major-44 hisax > alias char-major-45 hisax > > to /etc/modprobe.conf, but should not be necessary. Correct, because "service isdn start" will do this. > > Alexander > Christoph
