Setting up XGL in fedora is very easy nowadays , just run these commands 1. enable livna repository, then 2. yum install livna-config-display kmod-fglrx 3. get XGL packages from damaestro's page, and install them 4. livna-config-display --auto-xgl --tui --active 5. just to be sure, open system-config-display and check whether fglrx is selected or not 6. reboot 7. before login, make sure u select GNOME with XGL or KDE with XGL 8. Login 9. try running beryl note: I experienced problem with Xen kernel, so make sure you dont use that kernel for fglrx .. Fedora have grown to be a very easy distro (compared to the times I started with it, which was FC3) , its time for us to start promoting the easy parts of Fedora .. btw ... VMware doesnt support 3D hardware acceleration for graphics (not yet, but its coming soon) ... vmware virtual graphic card is not equal to your physical graphic card.. -- ----------------------------------------------- regards Hikaru ----------------------------------------------- Mohd Izhar Firdaus Bin Ismail Amano Hikaru 天野晃 「あまの ひかる」 mohd.izhar.firdaus@xxxxxxxxx ----------------------------------------------- kagesenshi.87@xxxxxxxxx Blog: http://kagesenshi.blogspot.com http://fedoraproject.org/wiki/MohdIzharFirdaus -----------------------------------------------
