Ashley M. Kirchner wrote:
We've got success. After the net install finished, first it wouldn't
boot at all, so I went into rescue mode and tried booting the drive then
only to have it tell it that it didn't have any bootable partitions.
So, a little bit of grub-install magic, the system now boots without a
problem.
Next step was to run 'yum update' ... and while installing
"kernel-PAE-2.6.31.9-174.fc12.i686", I saw these warnings/errors:
Possible missing firmware aic94xx-seq.fw for module aic94xx.ko
Possible missing firmware ql1800_fw.bin for module qla2xxx.ko
Possible missing firmware ql2500 for module qla2xxx.ko
Possible missing firmware ql2400 for module qla2xxx.ko
Possible missing firmware ql2322 for module qla2xxx.ko
Possible missing firmware ql2300 for module qla2xxx.ko
Possible missing firmware ql2200 for module qla2xxx.ko
Possible missing firmware ql2100 for module qla2xxx.ko
Is this something that should be addressed? For the record, the
machine has an Adaptec AIC-7895, so I don't *think* the 94xx is even
needed here.
Unless you want to run the qlogic controller, ignore this.
Is this the good "ServRAID" controller? It's an Adaptek with IBM firmware. Good
board. Ran a bunch of them, TB of little tiny drives.
--
Bill Davidsen <davidsen@xxxxxxx>
"We have more to fear from the bungling of the incompetent than from
the machinations of the wicked." - from Slashdot
--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list
Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
