Hi all, When I turn on the computer, the eth0 interface doesn't run, so I need to activate it using "service network start". These are setting of eth0 [CODE]# Realtek Semiconductor Co., Ltd. RTL8101E PCI Express Fast Ethernet controller DEVICE=eth0 BOOTPROTO=none HWADDR=00:19:66:40:cc:7a ONBOOT=yes DHCP_HOSTNAME=mishima NM_CONTROLLED=no TYPE=Ethernet USERCTL=no PEERDNS=yes IPV6INIT=no IPADDR=192.168.0.2 NETMASK=255.255.255.0 GATEWAY=192.168.0.1 DNS1=208.67.222.222 DNS2=208.67.220.220[/CODE] How can I do? Thanks in advance :-D :-D -- This is an email sent via The Fedora Community Portal https://fcp.surfsite.org https://fcp.surfsite.org/modules/newbb/viewtopic.php?post_id=294846&topic_id=62521&forum=10#forumpost294846 If you think, this is spam, please report this to webmaster@xxxxxxxxxxxxxxxx and/or blame marco.dr89@xxxxxxxxxx -- fedora-list mailing list fedora-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list Guidelines: http://fedoraproject.org/wiki/Communicate/MailingListGuidelines
