This is regarding a thread in the devel list: http://fcp.surfsite.org/modules/newbb/viewtopic.php?viewmode=flat&order=ASC&topic_id=45257&forum=11 [1] I hope you guys are reading this. I have managed to get mine working, but via a somewhat difficult route. I have used kmod-ndiswrapper and a driver I used (64 bit) successfully for some time. Whilst mucking around I noticed that after a rmmod ndiswrapper the logs showed a requirement for firmware, so I followed the link & instructions in the link (I needed to be using the ndiswrapper wireless to do this) : http://linuxwireless.org/en/users/Drivers/b43#devicefirmware [2] I used the firmware on that site, and populated /lib/firmware/b43 with the required firmware stuff. I then did rmmod ndiswrapper, modprobe b43 and about 20s later Network Manager re-established a connection using the b43-pci-bridge but the LED on the laptop wasn't on, but who cares. Yippee I though, not more ndiswrapper. However on next boot no wireless, even though all the logs seemed to show everything as OK. What I now do is use ndiswrapper to get the card into a warm state, and then rmmod ndiswrapper, modprobe b43 in rc.local I do this because the b43 driver runs my card better then ndiswrapper! It seems like I just need better firmware, however the b43-fwcutter doesn't recognise the checksum on the bcmwl5.sys I used for ndiswrapper. Where can I submit my bcmwl5.sys to be included as a recognised file by b43-fwcutter. Regards, Steve Links: ------ [1] http://fcp.surfsite.org/modules/newbb/viewtopic.php?viewmode=flat&order=ASC&topic_id=45257&forum=11 [2] http://linuxwireless.org/en/users/Drivers/b43#devicefirmware -- This is an email sent via The Fedora Community Portal https://fcp.surfsite.org https://fcp.surfsite.org/modules/newbb/viewtopic.php?post_id=230543&topic_id=49857&forum=24#forumpost230543 If you think, this is spam, please report this to webmaster@xxxxxxxxxxxxxxxx and/or blame fcp.surfsite.org@xxxxxxxxxxxxxxxxxxxxx
