Rick Stevens wrote:
On Fri, 2007-12-07 at 19:59 -0500, Robert L Cochran wrote:
Rick Stevens wrote:
On Fri, 2007-12-07 at 19:17 -0500, Robert L Cochran wrote:
Mikkel L. Ellertson wrote:
Robert L Cochran wrote:
I have a Toshiba Satellite P105-S6147 laptop with a standard Fedora 8
installation (except for the madwifi driver set) and the sound on it
doesn't seem to work. I get kernel messages like this, and a Skype test
call doesn't work.
Dec 7 17:42:04 eng2 pulseaudio[2949]: alsa-util.c: Device hw:0 doesn't
support 44100 Hz, changed to 48000 Hz.
Dec 7 17:42:04 eng2 pulseaudio[2949]: alsa-util.c: Device hw:0 doesn't
support 44100 Hz, changed to 48000 Hz.
Dec 7 17:42:04 eng2 pulseaudio[2949]: alsa-util.c: Cannot find mixer
control "Capture".
Any suggestions for how to fix this?
Thanks
It would help to know what audio the laptop has. You may need to add
an option to /etc/modprobe.conf to specify the configuration used.
Mikkel
Here is the audio device from lspci -vb:
00:1b.0 Audio device: Intel Corporation 82801G (ICH7 Family) High
Definition Audio Controller (rev 02)
Subsystem: Toshiba America Info Systems AC97 Data Fax SoftModem
with SmartCP
Flags: bus master, fast devsel, latency 0, IRQ 11
Memory at 00000000d0340000 (64-bit, non-prefetchable)
Capabilities: [50] Power Management version 2
Capabilities: [60] Message Signalled Interrupts: Mask- 64bit+
Queue=0/0 Enable-
Capabilities: [70] Express Unknown type IRQ 0
Here is the modprobe.conf:
cat /etc/modprobe.conf
alias eth0 e100
alias scsi_hostadapter libata
alias scsi_hostadapter1 ata_piix
alias scsi_hostadapter2 qlogic_cs
alias snd-card-0 snd-hda-intel
options snd-card-0 index=0
options snd-hda-intel index=0
Any suggestions are appreciated.
Thanks very much!
Can you run
cat /proc/asound/card0/codec#* | grep Codec
and post the results? This helps us sort out which of the plethora of
IHC7 cards you have.
Hi Rick,
cat /proc/asound/card0/codec#* | grep Codec
Codec: Conexant CX20549 (Venice)
I hope this helps?
Well, according to that, it's only seeing the modem part of your
sound card. It's not seeing the audio bit (and I should have caught
that from your lspci output).
So, something is very weird. I think F8 uses alsa 1.0.15 and it should
detect the chipset. The on-board sound is enabled in the BIOS, right?
Hi Rick,
The laptop model is actually a P105-S6147, not a P107-S6147 as my
subject line is erroneously stating. I had recently done a BIOS update
to BIOS version 4.00 for this machine. When I looked in the BIOS
options, I couldn't find one for enabling on-board sound. And I can't
remember whether I tested the audio under Windows Vista before, or
after, I did the BIOS update. I think it was before.
Also, I'm fairly certain there is only one keyboard shortcut for the
audio, Fn-and a little graphic for speakers, which seems to mute the
"Master" control or turn it back on. I'll double-check the
documentation. Pulseaudio is still complaining that it can't find the
"Capture" control.
Could I have made a mess of the audio with the BIOS update? Perhaps I
should backgrade the BIOS.
Bob
----------------------------------------------------------------------
- Rick Stevens, Principal Engineer rstevens@xxxxxxxxxxxx -
- CDN Systems, Internap, Inc. http://www.internap.com -
- -
- A day for firm decisions!!! Well, then again, maybe not! -
----------------------------------------------------------------------
