RE: Running Wireless and Wired eth connections at the same time

Hi Tim.

Thanks. You understand! However, with setting up two subnets, I have the
issue of the internal server not being able to see anything but the laptop.
I'd like a way to be able to allow the internal box to access the internet
via the laptop's wireless connection...

the basic issue is I'm not sure how to configure the laptop, and the
internal server to allow the internal server to be able to access the
internet as well...

here's what i have so far.

                                   >>>>  dns
internal box   <<<<  >>>laptop >>>+>>>   internet
  192.168.2.99   (eth0)     (ath0)
                192.168.2.33  192.168.1.33

the laptop can access both the internal box, and the internet
the internal box can only access the laptop...

i'm trying to be able to allow the internal box to be able to access
everything that the laptop can...

thanks



-----Original Message-----
From: fedora-list-bounces@xxxxxxxxxx
[mailto:fedora-list-bounces@xxxxxxxxxx]On Behalf Of Timothy Murphy
Sent: Sunday, October 14, 2007 7:35 PM
To: fedora-list@xxxxxxxxxx
Subject: Re: Running Wireless and Wired eth connections at the same time


sam wrote:

> I have a laptop that's connected to the 'net via the wireless port. It
> works. I also have the eth0 port that I use to connect to another box
> that's not connected to the 'net...
>
> so
>
>    internal box  >>>>laptop >>>>> internet
>                    (X)       (Y)
>
>   X - eth0
>   Y - ath0
>
> Each of the connections work.
>
> My question, how do I set them up (if possible) so I can have them both
> working at the same time. As it is now, it I have them both active, I can
> only access the connections to the 1st one that was active..
>
> The nics are on separate IP addresses..
>
> I've been looking high/low to try to figure this out. I need to accomplish
> this, as I'd like to update the internal computer with Fedora update rpms
> via yum, which requires internet access.

I may not have understood the question,
but I would use two different subnets, say 192.168.1.* and 192.168.2.*
for the two connections.

If you are not using dhcp you can do this by specifying the IP addresses
in /etc/sysconfig/network-scripts/ifcfg-[ath0,eth0] .

I think many people have two (or more) connections active
on the same computer.

--
Timothy Murphy
e-mail (<80k only): tim /at/ birdsnest.maths.tcd.ie
tel: +353-86-2336090, +353-1-2842366
s-mail: School of Mathematics, Trinity College, Dublin 2, Ireland

--
fedora-list mailing list
fedora-list@xxxxxxxxxx
To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list