Fedora Users — Re: Eth1 problems again

Timothy Murphy wrote:

david walcroft wrote:

Can someone tell how to get over this error please

[david@reddwarf ~]$ sudo service network restart
Shutting down interface eth0:                              [  OK  ]
Shutting down interface eth1:                              [  OK  ]
Shutting down loopback interface:                          [  OK  ]
Disabling IPv4 packet forwarding:  net.ipv4.ip_forward = 0
                                                           [  OK  ]
SIOCGIFFLAGS: No such device
Bringing up loopback interface:                            [  OK  ]
Bringing up interface eth0:
Determining IP information for eth0... done.
                                                           [  OK  ]
Bringing up interface eth1:  sysfs class device: Permission denied
Error, some other host already uses address 192.168.0.1.


How do eth0 and eth1 get their IP addresses?
>From dhcp?

Eth0 is dhcp,Ethe1 is static 192.168.0.1

What does "ifconfig eth1" say?

[david@reddwarf ~]$ ifconfig eth1
eth1      Link encap:Ethernet  HWaddr 00:E0:4C:14:1B:09
         inet6 addr: fe80::2e0:4cff:fe14:1b09/64 Scope:Link
         UP BROADCAST RUNNING MULTICAST  MTU:1500  Metric:1
         RX packets:3 errors:0 dropped:0 overruns:0 frame:0
         TX packets:7 errors:0 dropped:0 overruns:0 carrier:0
         collisions:0 txqueuelen:1000
         RX bytes:747 (747.0 b)  TX bytes:578 (578.0 b)
         Interrupt:22 Base address:0x8c00

[david@reddwarf ~]$

What does "route" say?

[david@reddwarf ~]$ route
Kernel IP routing table

Destination Gateway Genmask Flags Metric Ref UseIface

121.208.32.0    *               255.255.248.0   U     0      0        0 eth0
169.254.0.0     *               255.255.0.0     U     0      0        0 eth0
default         121.208.32.1    0.0.0.0         UG    0      0        0 eth0
[david@reddwarf ~]$

What is in /etc/sysconfig/network-scripts/ifcfg-eth1?

# Realtek Semiconductor Co., Ltd. RTL-8139/8139C/8139C+
DEVICE=eth1
ONBOOT=yes
BOOTPROTO=none
HWADDR=00:e0:4c:14:1b:09
NETMASK=255.255.255.0
IPADDR=192.168.0.1
GATEWAY=192.168.0.0
TYPE=Ethernet
USERCTL=no
IPV6INIT=no
PEERDNS=yes

[david@reddwarf ~]$ sudo ping -c 5 192.168.0.2
PING 192.168.0.2 (192.168.0.2) 56(84) bytes of data.
ping: sendmsg: Operation not permitted
ping: sendmsg: Operation not permitted
ping: sendmsg: Operation not permitted
ping: sendmsg: Operation not permitted
ping: sendmsg: Operation not permitted

What do I do to get ping to work  and is it part of this problem overall.
192.168.0.2 is on the other end of my crossover cable

Thanks  david