On Mon, 2007-09-10 at 18:12 -0300, Martin Marques wrote:
> Aaron Konstam escribió:
> > You are looking at this wrong. Here is my relevant modprobe.conf lines.
> >
> > alias eth0 tg3
> > alias eth1 ipw2200
> >
> > It is the module for the wireless NIC that is loaded not anything called
> > eth1. eth1 is created when the connection is made by NM.
>
> OK, seems like I'm getting closer.
>
> [root@localhost ~]# modprobe bcm43xx-mac80211
> [root@localhost ~]# iwlist scan
> lo Interface doesn't support scanning.
>
> eth0 Interface doesn't support scanning.
>
> wmaster0 Interface doesn't support scanning.
>
> wlan0 No scan results
>
>
> So the problem is that the module doesn't get loaded at boot time.
>
> Now that I've modprobed my wireless driver knetworkmanager shows the
> wireless network.
Did you post earlier what's in your /etc/modprobe.conf?
>
>
--
Matthew Saltzman
Clemson University Math Sciences
mjs AT clemson DOT edu
http://www.math.clemson.edu/~mjs
