Any suggestions for installing F7 on a system (dual 64-bit Opterons) with hardware raid? I'm not sure if the raid is connected to a controller on the mb or a separate controller. (When the system was set up, I remember there was some difficulty and I don't remember whether we ended up using the separate controller or the controller on the mb. This was originally set up with FC3 and was upgraded to FC4 and then FC6. Now the system won't boot after twice trying to install F7 - it gets a kernel panic - can't find a drive to boot from.) I don't understand much about raid drives (two 250gb drives set up to mirror each other). Would a good strategy be to disconnect the raid drive and try to install F7 again? In addition to the two SCSI raid drives, there are two ide drives and it booted from one of them. In all the previous versions of Fedora, the ide drives showed up as hda and hdd. Now, strangely, in disk druid with F7, they show up as SCSI sdc and sda drives! I don't understand how or why this is happening with Fedora 7. It doesn't seem to make much sense. I thought ide hard drives used hda, hdb, etc. drivers. Any suggestions on how to proceed would be appreciated. Rick B.
