frank wang wrote:
The maximum vesa driver resolution is 800x600. I could not increase
the resolution any more.
Thanks
Frank
Could you post the output from /sbin/lspci ? This should indicate what
pci devices you are using and may help you get a higher resolution.
Also, if you do not have a monitor display configured, you may only get
800x600 resolution as max. What did you set your display to for your
laptop? I have 1024x768 LCD listed the last time I needed to setup the
selection manually. With this installation it was detected automatically.
For comparison, here is my lspci output. The sound, Ethernet and
graphics was automatically and successfully setup. Now to help you with
the need for setup.
Jim
/sbin/lspci
00:00.0 Host bridge: ATI Technologies Inc AGP Bridge [IGP 320M] (rev 13)
00:01.0 PCI bridge: ATI Technologies Inc PCI Bridge [IGP 320M] (rev 01)
00:02.0 USB Controller: ALi Corporation USB 1.1 Controller (rev 03)
00:06.0 Multimedia audio controller: ALi Corporation M5451 PCI AC-Link
Controller Audio Device (rev 02)
00:07.0 ISA bridge: ALi Corporation M1533/M1535 PCI to ISA Bridge
[Aladdin IV/V/V+]
00:08.0 Modem: ALi Corporation M5457 AC'97 Modem Controller
00:0a.0 CardBus bridge: O2 Micro, Inc. OZ601/6912/711E0
CardBus/SmartCardBus Controller
00:0c.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21
IEEE-1394a-2000 Controller (PHY/Link)
00:10.0 IDE interface: ALi Corporation M5229 IDE (rev c4)
00:11.0 Bridge: ALi Corporation M7101 Power Management Controller [PMU]
00:12.0 Ethernet controller: National Semiconductor Corporation DP83815
(MacPhyter) Ethernet Controller
01:05.0 VGA compatible controller: ATI Technologies Inc Radeon Mobility U1
