Hi,
I now have a ipw3945.ko driver set up. The driver is being recognized
by system-config-network. But when I try to make the wireless eth1
active I get an error:
Determining IP information for eth1...failed; no link present. Check
cable?
iwconfig eth1 from command line produces
eth1 unassociated ESSID:"linksys" Nickname:"robo6.jsdey.com"
Mode:Managed Frequency=2.412 GHz Access Point:
Not-Associated
Bit Rate:0 kb/s Tx-Power:16 dBm
Retry limit:15 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:27 Missed beacon:0
I do know that the linksys WAP and ipw3945 wireless device are working
since I installed opensuse 10.2 and wireless connected out of the box.
Any suggestions will be greatly appreciated. And thanks for getting me
this far.
John
