Philip Walden wrote:
I have a Airlink AWLL3026 using the zd1211rw driver. I am using WEP
with a hex key and dhcp client to get a IP number. I can see the
device initializing and connecting to eth1 using dmesg.
I am not using NetworkManager, just the System>Administration>Network
gui.
For the life of me I cannot get this adapter to connect and get an IP
number on system start or by itself. In fact the only incantation that
seems to work is to :
1. deactivate the wireless eth1
2. connect and activate the wired lan eth0 to get an IP number
3. deactivate the wired eth0
4. activate eth1 which then says dhcp client is already busy, but now
I have an active working wireless connection???!!
So this tells me that the WEP is correctly set up, but the dchp
request is not working with the wireless eth1.
Any ideas?
Well after much fiddling, I was unable to get a reliable activation of eth1.
So I switched to NetworkManager, as I had not had much luck with it in
FC5 with a different wireless card and had stopped using.
Well again after some fiddling, NetworkManager seems to connect reliably
on login. It is annoying that it asks for the keyring password just
after entering the login password. A rudimentary attempt to stop it
doing this by editing the /etc/pam.d/gdm file were unsuccessful. Oh well
it is good enough for now.
