On Wed, Nov 01, 2006 at 09:48:34AM +0000, Tim Waugh wrote:
> Do you remember how it was configured under FC5? It might be that you
> were using HPLIP. If you install the 'hplip' package (if not already
> installed), and start it if not already running (service hplip start),
> and then create a new queue, does that work? Be sure to select the
> device that says 'HPLIP' in the name.
Thanks guys for the suggestions. However, it turns out that my printer
decided to go faulty at coincidentally the same time as I installed FC6.
It works for a few minutes, then disappears off the USB horizon. A power
cycle gives it a few more minutes.
Still, it would be nice if CUPS actually gave a *useful* error message for
once in its life :-(
--
print+qq&$}$"$/$s$,$*${d}$g$s$@$.$q$,$:$.$q$^$,$@$*$~$;$.$q$m&if+map{m,^\d{0\,},,${$::{$'}}=chr($"+=$&||1)}q&10m22,42}6:17*2~2.3@3;^2dg3q/s"&=~m*\d\*.*g
