On Mon, 21 Aug 2006 09:46:24 -0500, Joe W. Byers wrote > I appreciate your responses. > > I can access the the outside world from both my other computers: a > XP system and a RHEL4 linux server. > > Using route -n I get the same results as is the output you list > below. My linux server returns the last column as eth0 since it is > connected through a cable. > > This happens with the F5 box whether or not I have the firewall > running or WEP enabled on the router, or any combination of these. > > I feel like it is some small configuration problem because this HP > machine worked fine with my network with Windows 98 running on it > before I installed Fedora 5. > > I have tried the KDE wifiwireless and it tells me no signal trying > to find my Network. I do not think this is correct because I have > not moved the computer or the router and the wireless connection > worked when W98 was on the machine. When I scan for networks it > shows the networks in the neighborhood that I have seen before. > > If you tell what information might help us, I can pipe the command's > results to a txt file and include them in a reply since I have samba > working. I just do not know what I need to look at anymore. > > Thank you > > Andy Green wrote: > > Wolfgang Gill wrote: > > > >>> My problem is that I can access all my computers from the HP and they > >>> can access the HP, BUT I can not get outside my LAN. > > > >> Sounds like the ISP's DNS addresses are missing.. Does the router forward > > > > How about no default route is configured? > > > > route -n > > > > should have a line at the bottom marked up as UG, this is where your > > machine sends packets if they don't match any of the other routes. Mine > > looks like this for example, so 192.168.0.1 is the router that goes out > > to the world > > > > # route -n > > Kernel IP routing table > > Destination Gateway Genmask Flags Metric Ref Use > > Iface > > 192.168.0.0 0.0.0.0 255.255.255.0 U 0 0 0 > > wlan0 > > 169.254.0.0 0.0.0.0 255.255.0.0 U 0 0 0 > > wlan0 > > 0.0.0.0 192.168.0.1 0.0.0.0 UG 0 0 0 > > wlan0 > > > > -Andy Since your using KDE.. Goto the System folder and click on Netowrk Device Control. Then click on configure.. And check the DNS tab, to see if there is in fact a DNS server address(es) in there.. As from what you mentioned, that the system can see all the other PC's on the network and visa vera. So it only leaves whether it's getting a DNS server address. Without it, you can't browse the internet. (Unless you have the IP address of the webpage you need to access, and your internal web server is either accessed via a direct IP address or NetBIOS name). I had the exact same problem on one system, and it was missing the DNS server address(es), once I fixed that, I could access the internet again.. (As there was a small glitch in the router which, wasn't forwarding the DNS Address when the system requested an IP address.(Via DHCP). ). You could also insert it manually, (By getting that info from a working system), and see if that helps.. Wolf -- Open WebMail Project (http://openwebmail.org)
