Other way around to do all pdf converting stuffs is 0. Open file in a corresponding application 1. Select "print" from menu as select to file 2. Then you will get .ps file 3. convert ps file to pdf by ps2pdf Hope this is usefull!!!!!! Regards Jerin On Thu, 2006-06-01 at 21:49 +0800, Stephen Liu wrote: > Hi folks, > > Any folk has experience on following small package? > > Download PDF Converter for Linux on > http://www.amyuni.com/en/support/downloads.html > > Changed to the directory where Convert2PDF.tar.gz was stored > > Extracted the file > # tar zxf Convert2PDF.tar.gz > # cd installation/ > # ls > autostart confirmdlg convert2pdf.conf convertps2pdf > install.sh > C2PClient conprop convert2pdf.sc converttext2ps > msgbox > configure consave convert2pdfserv.conf conview > uninstall.sh > configureuser.sh convert2pdf convertdlg delegates.mgk > * End * > > # ./install.sh > cp: cannot stat `C2PDemoClient': No such file or directory > ./install.sh: line 38: 2660 Segmentation fault ./configure > * end * > > line 38=./configure > > # ./uninstall.sh > ./uninstall.sh: line 5: service: command not found > * end * > > Can't proceed further. > > There is no README file there. Please shed me some light. TIA > > B.R. > SL > The information contained in this electronic message and any attachments to this message are intended for the exclusive use of the addressee(s)and may contain confidential or privileged information. If you are not the intended recipient, please notify the sender or administrator@xxxxxxxxxxxxxxx
