Can someone point me in the right direction to find a procedure for
installing a second ethernet card in this FC-5 system?
The first one I installed several years ago and I don't recall any
problem doing so. Now I need a second port to connect a "wireless
bridge" and I can't seem to get the needed port installed correctly.
One problem is that with "system-config-network" it keeps coming up as
dev28753 instead of the expected eth1.
lspci reports:
for eth0:
00:0f.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado]
(rev 6c)
New card, should be eth1:
00:10.0 Ethernet controller: Linksys NC100 Network Everywhere Fast
Ethernet 10/100 (rev 11)
Any help appreciated.
Than you.
Bob Goodwin Zuni, Virginia
