2.6.16-1.2080_FC5smp gcc (GCC) 4.1.0 20060304 (Red Hat 4.1.0-3) spca5xx-20060402 Compiles and installs fine. Modprobe spca5xx works fine. Here's the /var/log/messages output of doing a "modprobe spca5xx": Apr 16 12:18:39 electron kernel: Linux video capture interface: v1.00 Apr 16 12:18:39 electron kernel: usbcore: registered new driver spca5xx Apr 16 12:18:39 electron kernel: /root/spca5xx-20060402/drivers/usb/spca5xx.c: spca5xx driver 00.57.11 registered Next, I plug in the camera, and /var/log/messages gives: Apr 16 12:20:33 electron kernel: usb 1-2: new full speed USB device using uhci_hcd and address 4 Apr 16 12:20:33 electron kernel: usb 1-2: configuration #1 chosen from 1 choice Apr 16 12:20:33 electron kernel: hub 1-2:1.0: USB hub found Apr 16 12:20:33 electron kernel: hub 1-2:1.0: 4 ports detected Apr 16 12:20:34 electron kernel: usb 1-2.4: new full speed USB device using uhci_hcd and address 5 Apr 16 12:20:34 electron kernel: usb 1-2.4: configuration #1 chosen from 1 choice Apr 16 12:20:34 electron kernel: /root/spca5xx-20060402/drivers/usb/spca5xx.c: USB SPCA5XX camera found. Type Creative Live! Zc301+Tas5130c Apr 16 12:20:34 electron kernel: /root/spca5xx-20060402/drivers/usb/spca5xx.c: [spca5xx_probe:8301] Camera type JPEG Apr 16 12:20:35 electron kernel: /root/spca5xx-20060402/drivers/usb/zc3xx.h: [zc3xx_config:530] Find Sensor HV7131R(c) Apr 16 12:20:35 electron kernel: /root/spca5xx-20060402/drivers/usb/spca5xx.c: [spca5xx_getcapability:2198] maxw 640 maxh 480 minw 176 minh 144 But when I run spcaview, it freezes the machine. For obvious reasons I can't cut-n-paste the screen output. Any ideas? -- This is an email sent via the webforum on http://fcp.homelinux.org http://fcp.homelinux.org/modules/newbb/viewtopic.php?post_id=79306&topic_id=19527&forum=28#forumpost79306
