Lyvim Xaphir wrote: > > Has this machine done any updates or is this the original binaries off > of the FC5 install cds? > > > Given the information you have gathered up to this point, I would put > the machine in runlevel 3 and then start experimenting with different X > resolutions. Unless that is the machine has gone thru updating. > > > LX No, there were no updates. I've never been able to get past the configuration procedure that happens when you boot the first time after the install. The installation was off an unmodified FC5 distribution. Since my previous email I reinstalled FC5 from scratch. Then I went through the first boot configuration process, but this time I did NOT alter my display settings or change the SELinux setting. I got the same problem as before. The screen went grayish-blue, then blank, and the system hung. One other thing may be worth mentioning. The installation correctly identified the graphics chipset on the motherboard and the monitor model. However the initial display settings during the first boot were 600x800. This is almost certainly a lower resolution that was used during the installation procedure. I don't remember the monitor coming up with such a low resolution when I installed FC5 on my other Linux box. This problem is baffling. I wonder if there is a log file somewhere that might reveal something. I could boot into Linux rescue mode and take a look, if I knew what to look for. :-) Debbie
