okay, i modified the artec_eplus48u.conf file and trimmed it up so it
only contains information about my scanner, i'm using the usb version,
so i think i have it right but it still won't work; merely replies with
invalid argument. i'm certain this will work if i or someone else
(anyone!) can figure it out and post their answer!
------------------------------------------------------------------------------------------------------------------------
# artec_eplus48u - SANE Backend configuration file
# For use with the Artec E+ 48U scanner
# This scanner is also sold as
# Tevion MD 9693, Medion MD 9705, Medion MD 9693,
# Trust Easy Webscan 19200, Memorex Mem 48U or Umax AstraSlim SE.
#
# The USB section:
# each device needs at least the following line:
# usb vendor-ID and product-ID
# Every device configuration in this file must begin with an usb entry.
usb 0x05d8 0x4003
#
# Path to the firmware file
# This file comes with the Windows driver
# The scanner won't work without it
#
option artecFirmwareFile /usr/share/sane/artec_eplus48u/Artec48.usb
option ePlusPro 0
#
# for adjusting the default gamma values
#
option redGamma 1.0
option greenGamma 1.0
option blueGamma 1.0
option masterGamma 1.9
#Use this options to set the default offset and exposure time values.
option redOffset 0x28
option greenOffset 0x2f
option blueOffset 0x2f
option redExposure 0xa7
option greenExposure 0x116
option blueExposure 0xdc
# The vendor and model string
# This string is displayed by the frontends. If you do not want to get your
# scanner reported as "Artec E+ 48U", then change the option accordingly.
option vendorString "Artec"
option modelString "E+ 48U"
#
# device-name
#
# If autodetection does not work, then you can specify the device here
# The device entry must be the last one in this config file (or the last
one before a
# new usb entry).
#If you are using libusb, a device looks like this:
#device libusb:001:002
device libusb:001:002
#If you are using the scanner module (kernel driver), a device looks
like this:
#device /dev/usb/scanner0
#
# Path to the firmware file
# This file comes with the Windows driver
# The scanner won't work without it
#
option artecFirmwareFile /usr/share/sane/artec_eplus48u/1200.usb
