I had a similar thing happen to me a month or so ago. I was using seagate (sata250GB) drives and found I was getting many singular errors which then spread to multiple drives within a matter of hours. I was left in the situation where one drive had physically failed, and one was left corrupted. Out of the six drives, two were dead according to mdadm so I thought I was stuffed. I would strongly recommend trying mhdd and running the remap function. This allowed me to get the supposedly dead drive back (run it a few times, and yes I did pop the drive in the freezer for 30 minutes beforehand!). I was then able to bring that drive up as good and reassemble. I then bought more drives and now rsync backup to another machine! My problem was actually to do with having 4x1GB of RAM, with two sticks not fully matched. I have since tested all of my RAM and have to run it at a lower spec. I would recommend running memtest+ test 5 on each stick and building up combinations from there. The same drives are now working flawlessly. Regs, Andy On 3/14/06, Reuben D. Budiardja <techlist@xxxxxxxxxxxxxxxxxxxxxxx> wrote: > > Hello, > First, I apologize if this is rather OT. > > I had multiple hard-drives failure yesterday on a RAID 5 array. Two out of > three drives died almost at the same time, rendering the RAID array useless. > I tried to recover by doing --assembly and even --assembly --force but it > failed. The raid device /dev/md0 run with damaged fail system after that, and > fsck would not fixed it, and message scrolled on the screen and log files > indicating that writing to the two drives were really failed. SMART reported > the same thing. So I lost all data. > > There is a very very small probabilities that something like this can happen. > However, in the last two years, I've had a strings of bad luck with these > hard drives: all Maxtor DiamondMax 250 GB IDE HD. In the last two years, I > had 4 drives failure with these drives (including the ones yesterday). The > two failures in the past, I had a replacement drives sent for both of them > since they were under warranty and it indicated a fail drive with Maxtor's > diagnostic software. > > I am using these consumer level drives thinking that I could build a rather > cheap backup system. The machine, running RAID 5, did backup for some > machines in the network using rsnapshot, twice a day. The size of data being > backed-up is about 250~300GB. The hard drives is on a Promise controller > running software RAID 5 > > So my questions having said all that, is there any thing else other than a > real hard-drive problem that would cause something like this ? > In other words, could the problem be in the controller, motherboard, etc other > than the hard drive itself that would cause hard-drives to fail like that ? > Or is it just Maxtor makes bad drives ? > Or is a consumer level hard-drive just cannot be used for this kind of work > > I am hoping for comments, etc. Thank you in advance. > > RDB > -- > Reuben D. Budiardja > Dept. Physics and Astronomy > University of Tennessee, Knoxville, TN > > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-list >
