Jeff Vian wrote: > On Sat, 2006-02-25 at 12:01 +0000, Paul Howarth wrote: > >>On Sat, 2006-02-25 at 03:41 +0100, l.schneide wrote: >> >>>Hi all >>> >>>I got a probleme to configure my nic card on fedora core 4. I use the >>>network configuration under Gnomeand i can't cofing. the NIC >>>I got a 3com Etherlink III on IRQ 11 and I/O 0x300. I tied a lot of >>>think but i can make it to start. >>>first In what field do i put the I/O adress ? >>>and second in what file the config is write to see if it's right ? >> >>The configuration should end up in /etc/modprobe.conf >> > > The driver may need to be entered there, but the configuration is done > by system-config-network. > > Go to Desktop - System Settings - Red Hat Network Configuration > That will open up the tool to actually enter and save the configuration > settings. > I think he is talking about the I/O and IRQ configuration, and that needs to be in /etc/modprobe.conf because it has to be set when the driver loads. If I remember correctly, this is an older ISA NIC that you have to run a DOS setup tool to set the card, and then you have to tell the driver what you set the card to. Mikkel -- Do not meddle in the affairs of dragons, for thou art crunchy and taste good with Ketchup!
