Jdek wrote:
Le vendredi 16 décembre 2005 à 12:21 -0500, bobgoodwin a écrit :
Warren Sturm wrote:
Can you take a look in your /var/log/messages file and see if there is
any error associated with eth0. Another thing to maybe try is to clear
the bios ESCD or DMI. This may have been what worked for me with and
old recalcitrant system when moving from 2.6.12 to 2.6.13 first and
later 2.6.14. It is now running 2.6.14-1.1653.
On Thu, 2005-12-15 at 20:53 -0500, bobgoodwin wrote:
I updated Kernel 2.6.12-1.1447_FC4 to
2.6.14-1.1644_FC4 which seems to be an improvement. I
notice that "sensors" works for the first time since
RH9 but during boot it fails to find eth0 and as a
consequence Firestarter crashes and leaves me with no
firewall. Normally eth0 is used to connect to another
computer while the internet connection is via a dial up
modem, the only service available in this rural area.
Things still work normally with the 2.6.12 Kernel I am
using now.
Any suggestion on where to look for the ethernet problem
is appreciated.
Bob Goodwin
I updated the Kernel via yum again this morning to 2.6.14-1.1653_FC4
which made no difference.
I also looked at the BIOS set up , the only DMI option's I have seem to
relate to logging and about all I could do there was "mark as read."
During boot I see a message about eth0 FAILED streaming by and dmesg
shows: 3c59x: Unknown parameter `irq'
And modprobe reports:
modprobe -v 3c59x
insmod /lib/modules/2.6.14-1.1653_FC4/kernel/drivers/net/3c59x.ko irq=10
FATAL: Error inserting 3c59x
(/lib/modules/2.6.14-1.1653_FC4/kernel/drivers/net/3c59x.ko): Unknown
symbol in module, or unknown parameter (see dmesg)
dmesg shows: 3c59x: Unknown parameter `irq'
System-config-network and Webmin both fail to configure eth0, producing
error messages after going through the configuration routine.
I can still use the earlier Kernel but would like to get this
straightened out.
Thanks.
Bob Goodwin
Have a look in your /etc/modprobe.conf and check for alias eth0 (followed by your network module, depending on the chipset on your MB)
Try and comment the line where the options of the network module
displays "irqnn"
Perhaps should help
Jdek
Ok, it looks like that fixed the problem. I commented the
line as you suggested and so far so good! It looks like
things are working again. I am writing this using the
newest Kernel ...
cat /etc/modprobe.conf
alias snd-card-0 snd-ens1371
options snd-card-0 index=0
options snd-ens1371 index=0
remove snd-ens1371 { /usr/sbin/alsactl store 0 >/dev/null
2>&1 || : ; }; /sbin/modprobe -r --ignore-remove snd-ens1371
alias usb-controller uhci-hcd
alias net-pf-10 off
# options 3c59x irq=10
alias eth0:0 3c59x
Thank you for the assistance.
Bob
