At 10:43 PM +0200 6/12/05, Alexander Dalloz wrote: >Content-Type: multipart/signed; micalg=pgp-sha1; > protocol="application/pgp-signature"; > boundary="=-MBZyDyTCCmXep4xFgiXH" > >Am So, den 12.06.2005 schrieb Tony Nelson um 20:46: > >> Yes, thanks, that seems to have been it. Got the FC3 core pkg. I'm still >> configuring, trying to decide where to put the files. I had to create >> /etc/modules.conf. I'm not sure which /etc/rc* file to put stuff in; >> rc.local seems better than rc or rc.sysinit. If I should copy >> /prog/init/lm_sensors.init to /etc/rc.d/init.d/lm_sensors for this stuff to >> work, where is /prog? There is already a file /etc/rc.d/init.d/lm_sensors. > >> TonyN.:' <mailto:tonynelson@xxxxxxxxxxxxxxxxx> > >You should have been asked to let /etc/sysconfig/lm_sensors be created. >There the required modules are set. You do not need /etc/modules.conf. >/etc/init.d/lm_sensors is the start script the lm_sensors RPM ships >with. Do not exchange it. > >Alexander I accepted the defaults for everything sensors-detect asked (mostly "yes", none of the defaults seemed stupid to my limited knowledge). It told me to do all the things I mentioned, though the directions it printed may have been wrong. Its man page was not informative. I'll try removing /etc/modules.conf. Was /etc/rc.local the right place to put stuff? It detected ISA sensors that seem to not be connected, so I have commented out the ISA lines. FWIW, here's info copied (by hand) from SpeedFan running on WinXP: SpeedFan 4.02 DLPORTIO.DLL properly activated GIVEIO properly initialized (autoinstalled) Linked ISA BUS at $0290 Linked VIA VT82C686 SMBUS at $E800 Scanning ISA BUS at $0290... INFO: ISA seems to be unused Scanning SMBus at $E800... WARNING : VIA686 sensors are disabled Asus AS99127F(31) (ID=$31) found on SMBus at $2D LM75 found on SMBus at $48 LM75 found on SMBus at $49 Found WDC WD1200JB-75CRA0 (117.2GB) End of detection CPU?: 59C MB?: 42C VCOREA: 1.79V VINR0: 0.10V +3.3V: 3.52V +5V: 4.97V +12V: 12.22V -12V: -12.43V -5V: -5.06V Info: VIA VT82C686 SMBus base address $E800 revision 00 [checked] I/O enabled ____________________________________________________________________ TonyN.:' <mailto:tonynelson@xxxxxxxxxxxxxxxxx> ' <http://www.georgeanelson.com/>
