On Sun, 2005-06-05 at 08:52 -0500, Jeff Vian wrote: > On Sun, 2005-06-05 at 10:26 +0100, Ashley Kitson wrote: > > Having checked elsewhere and drawn a blank, I hope I might get some help > > here :-) > > > > I've just bought a new PC, which has a Foxconn motherboard running AMD > > Sempron and integrated SiS (741 series) video controller. When Fedora 3 > > installed and on subsequent delves into "system settings-display" it > > autorecognises the video card as NVIDIA GeForce FX (Generic). > > > > The problem with this is that I cannot use the screen saver as the > > screen freezes after about 10 minutes of inactivity and the only > > solution is a hard reset. So I'd like to try the SiS driver. > > > > However..., The SiS driver doesn't work. I've read the Xorg spec sheet > > for the sis driver and selected the SiS 315 (being the correct series > > for the 741 chip). When the X system tries to re-initialise, it does > > not recognise the hardware. > > > > I've included X output below and would appreciate any help > > Kind regards > > Ashley > > > > > The sis driver supports the chipsets listed in the Xorg.0.log output and > yours is not one of those. The chipset is likely one of the geforce > chipsets as it is autodetected as a GeForce FX 5200. > > I assume, although you did not say, that the original driver in the > xorg.conf file was the "nv" driver. > > Your 'freeze' after a short time is typical of using gl screensavers on > a system with a 2d only driver and the gl screensavers need a 3d driver. > > A fix might be to go to www.nvidia.com and download and install the > 'nvidia' drivers and install them. The nvidia driver does have 3d > support and fixed my problem with the freezing when using random > screensavers and the generic 'nv' driver. Better yet, go to http://rpmlivna.org and download their version of the driver. Its installation routine is much more "Fedora friendly" than the NVidia installer (uses RPM and doesn't step on other gl libraries). For Fedora Core 3, browse to the following directory: http://rpm.livna.org/fedora/3/i386/RPMS.stable/ >From there, you'll need: 1) kernel-modula-nvidia-<your kernel version>-1.0.7174-0.lvn.1.3.<your Intel chip>.rpm 2) nvidia-glx-1.0.7174-0.lvn.1.3.<your Intel chip>.rpm Just download, install and you're pretty much there. Alternatively, you can build your own from the source RPM, but installing these two will do the trick just as well on a FC3 system. Good luck! Chris -- ====================== When the solution is simple, God is answering. -- Albert Einstein
