On Sunday 22 May 2005 17:35, Lai Zit Seng wrote:On Sat, 21 May 2005, Aaron O'Hara wrote:On Sun, 2005-22-05 at 09:28 +0800, Lai Zit Seng wrote:On Sat, 21 May 2005, Aaron O'Hara wrote:What scripts/urls are you using to have load balanced, failover ready internet connections on single FC2/3 box?
I've only seen a couple simple load balancing routing table howto's.
Are you referring to having highly-available network access to your single FC2/3 box?
I suppose in that case you should at least be looking at having at least two network links to two different network switches in the same logical network, and have both ports run together as a bridge.
I'm referring to an environment where an office has 1 FC Firewall with 2 different ISPs providing internet access. While both are up, utilize both (perhaps with a preference to one if there are different caps), when one goes down, use the one that's up.
I see. I haven't come across any nicely packaged software that does this... so far all that I've seen so far are a bunch of scripts... sorry. I assume you've already Google'd and seen the most common stuffs :)
I do not have a solution but lets see what information we have?
1. I know that one method is called Multilink
2. I know it works with PPP (does it work with PPPOE too?)
3. I know that one method is called EQL and is "serial line load balancing" but the ISPs dosn't seem to provide EQL.
4. In general it is called "Load Balancing"
I believe all the above works only if you connect up to the same ISP. I think the original poster wanted to connect to different ISPs. So it gets a little more messy :)
Regards,
.lzs -- http://popoheads.com/~lzs/
