Hi, I have a problem with a DPT i2o SCSI adapter it has a RAID 5 set and a HP tape and it worked without problems with Fedora 1. Recently I had to reinstall and I used FC3, now the tape is not seen anymore. I tried to use the Rescue mode of FC1 and it was still there so no HW problems. The difference seems to be that FC1 used the dpt_i2o driver while FC3 uses i2o_block and it seems it doesn't work properly, it doesn't even show in /proc/scsi, and dmesg shows this: SCSI subsystem initialized I2O Core - (C) Copyright 1999 Red Hat Software i2o: max_drivers=4 i2o: Checking for PCI I2O controllers... i2o: I2O controller found on bus 0 at 73. i2o: PCI I2O controller at F4000000 size=1048576 i2o: using write combining MTRR i2o: MTRR workaround for Intel i960 processor iop0: Installed at IRQ 177 iop0: Activating I2O controller... iop0: This may take a few minutes if there are many devices iop0: HRT has 0 entries of 16 bytes each. iop0: Controller added I2O Block Storage OSM v0.9 (c) Copyright 1999-2001 Red Hat Software. block-osm: registered device at major 80 block-osm: New device detected (TID: 209) i2o/hda: i2o/hda1 i2o/hda2 i2o/hda3 Is there a known problem or do I need some options in the configuration? Or maybe there is a different driver for other devices attached to the i2o. Thanks for any help. Ciao, GiP
