gw GW route packets via a gateway. NOTE: The specified gateway must
be reachable first. This usually means that you have to set up a
static route to the gateway beforehand. If you specify the
address of one of your local interfaces, it will be used to
decide about the interface to which the packets should be routed
to. This is a BSDism compatibility hack.After reading the above, I tried both:
route add default gw <own-ip-addr> and route add default gw <router-ip>
where <router-ip> is of course the IP of network 16.140.128's router (one of them), and this lets me onto the wire, but only for the local network. I all the other networks are still unreachable.
Paul Howarth wrote:
On Tue, 2005-02-08 at 14:16 -0500, Douglas Frank wrote:
I'm unable to reach local networks from the new fc3 box, that I've never had trouble with using other unixes (or Slackware for that matter). It's been my experience that simply kicking off routed or gated was all it took to make the world accessible. FC3 is different!
We have several networks here at work and my question is, how do I set up the routing table to reach them? Example:
16.140.160/24 <-- fc3 box is on this one 16.47.32/24 16.32.176/24
-- Douglas Frank HP Co. 110 Spit Brook Rd. Blessed are the Bewildered Nashua, NH 03062 USA for they won't notice
