On Mon, 2005-01-10 at 19:31 +0100, Alexander Dalloz wrote: > On the SANE project website check whether your scanner is supported. If > not, no further steps can be gone from here. If it is supported, then > plug it in as your SCSI device and reinitiate a SCSI bus scan (or > reboot). Starting xsane then should recognize the scanner. You may need > to adjust permissions for the SCSI generics device the scanner is > attached to. > Well the device is supported. However, with the scanner plugged in, modprobe initio hangs the system. I'm recompiling the kernel again with some minor changes. > -- > fedora-list mailing list > fedora-list@xxxxxxxxxx > To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list ________________________________________________________________________ Total Quality Management - A Commitment to Excellence http://www.TQMcube.com