[root@Home ~]# iwconfig eth1
eth1 unassociated ESSID:off/any
Mode:Managed Channel=0 Access Point: 00:00:00:00:00:00
Bit Rate=0kb/s Tx-Power=off
RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
[root@Home ~]#
On Thu, 30 Dec 2004 10:35:44 -0400, Patrick Boutilier
<boutilpj@xxxxxxxxxxx> wrote:
> <snip>
> >>
> >
> >
> > Update
> > i have the driver installed...it is listed as one of my devices eth1
> > shows intel 2200bg when i go to activate it, says can't acquire an
> > ip and to check the to see if the "Cable is unplugged" umm hello
> > it's wireless !!!
> > so where do i go from here? firmware is installed, as mentioned
> > before, where do i install the wireless tools? whats this about
> > turnning on the radio in my kernel?
> >
> > the instructions to build this driver read like sterio
> > instructions... they're all over the place so i don't know which end
> > is up.
> > link for instructions http://ipw2200.sourceforge.net/INSTALL
> >
> > i'm close (I think) to getting this to work
> > thanks
>
> What does
>
> iwconfig eth1
>
> say?
>
> --
> fedora-list mailing list
> fedora-list@xxxxxxxxxx
> To unsubscribe: http://www.redhat.com/mailman/listinfo/fedora-list
>
--
James Lawrence
Rochester NY
