Hi all. I have a kanguru micro cf drive and I can access the cf card when attached using /dev/sda1. I cannot access the internal flash of the reader (mine has 32MB on board) using FC3. I used to be able to access the internal flash as /dev/sda when I was running FC1, but not in FC2 and 3. Is there something I can activate in the kernel or a module to install to make the kernel look into the internal rom? When I plug in the device without a cf card in, dmesg says usb 2-2: new full speed USB device using address 5 scsi3 : SCSI emulation for USB Mass Storage devices Vendor: USB CARD Model: READER Rev: 0.20 Type: Direct-Access ANSI SCSI revision: 02 Attached scsi removable disk sda at scsi3, channel 0, id 0, lun 0 USB Mass Storage device found at 5 Device not ready. Make sure there is a disc in the drive. thanks, Eric
